Fuel pump installation directions

B Disconnect any hoses attached between the fuel tank and the vehicle. Be careful when disconnecting fuel lines to avoid fuel spillage. Note all hose connections to make certain hoses are properly reconnected upon installation. C Disconnect and remove fuel filler neck if necessary. D Support fuel tank and remove retaining straps to allow tank to be removed from vehicle. Remove the fuel tank being careful to avoid spilling fuel.

A Thoroughly clean all dirt and debris from the top of the tank. Clean out any dirt from around the locking ring and retainer. This must be done to prevent dirt or foreign material from falling into the fuel tank while removing the bracket. B Remove the bracket retainer with proper service tools. C Carefully remove the bracket from the fuel tank.

Take care not to bend the float arm or scratch the float when it is removed. Discard the fuel tank to bracket o-ring seal. If excessive, clean out the fuel tank before installing the bracket. Also use care not to fold or twist the filter as this could cause restricted fuel flow. Install the bracket retainer. Reconnect all lines and hoses and tighten securely. Connect the electrical connections. NOTE: Be sure to clean up any fuel spills before proceeding. Correct leaks if any exist.

NOTE: This pump will not remedy malfunctions of the regulator, injectors or other fuel system components. A Disconnect the electrical connector at the fuel tank to main harness connector, supporting and partially lowering the tank if required. B Disconnect any hoses attached between the fuel tank and the vehicle. Be careful when disconnecting fuel lines to avoid fuel spillage.

Note all hose connections to make certain hoses are properly reconnected upon installation. C Disconnect and remove fuel filler neck if necessary. D Support fuel tank and remove retaining straps to allow tank to be removed from vehicle.

Remove the fuel tank being careful to avoid spilling fuel. Bracket Removal. A Thoroughly clean all dirt and debris from the top of the tank. Clean out any dirt from around the locking ring and retainer. This must be done to prevent dirt or foreign material from falling into the fuel tank while removing the bracket. B Remove the bracket retainer with proper service tools.

C Carefully remove the bracket from the fuel tank. Take care not to bend the float arm or scratch the float when it is removed.

Discard the fuel tank to bracket o-ring seal. Remove And Replace Pump. If excessive, clean out the fuel tank before installing the bracket. Also use care not to fold or twist the filter as this could cause restricted fuel flow. Install the bracket retainer. Install Fuel Tank Into Vehicle. Reconnect all lines and hoses and tighten securely. Connect the electrical connections.